Why Our Baths Are Best

This is why our Baths are Stronger, Tougher and built to last.

The most important part of any Walk in Bath is the Frame.  It needs to be welded together, not bolted, a bolted frame will eventually move. It needs to be made by highly skilled craftsman and have all round quality.

All our competitors use a steel frame.  What happens when you get water or condensation on steel? it eventually rust.
Our frame is Stainless Steel.  It is the only bath on the market with a stainless Steel frame.  Stainless Steel does not rust, is stronger and gives you that feeling of longevity.

The next most important aspect is the Walk in Bath is design and manufacturing
All our Baths are manufactured as below.

There are FOUR layers of high-efficiency glass-fibre used to build up the thickness of the whole body. Most Walk in Baths have only two layers. 
We also thicken the main supporting areas  around the corners and around the back of the seat where we use FIVE layers of high-efficiency glass-fibre and we use SIX layers in the floor area.
All the Air Jet and Water Jet holes on our whirlpool/spa models are re-enforced and we apply a section of marine ply glass-fibered to the underside of the base not chip board.

The Stainless Steel Frame will prevent any rusting and ensure the rigidity of the Walk in Bath .  Please note the hygienic bidet cutaway in the photo.

The below photos show the fibreglass body, Air Manifold and Jet attachment, Blower and Stainless Steel plate and please note the general tidiness and attention to detail of the whole system.